A toilet that runs, leaks, or will not flush right is more than an annoyance, a running toilet alone can waste hundreds of gallons a day and quietly run up your water bill. We repair every common toilet problem the same day, and when a toilet is past fixing, we install a new water-saving model cleanly, with the old one hauled away. Flat price either way, and no mess left behind.
Most toilet faults come down to a handful of worn parts, and most are quick fixes once you know the cause.
A toilet that runs constantly, or cycles on its own, is almost always a worn flapper or a faulty fill valve letting water slip from the tank into the bowl. It is the most common toilet repair we do, and one of the most wasteful to leave, so we replace the worn part and stop the water loss.
If the bowl barely clears or you have to hold the handle, the cause is often a worn flapper closing too soon, a clogged rim jet, or a low tank water level. We find which and restore a full, clean flush.
A handle that does nothing usually means a broken flush chain, lever, or flapper inside the tank. These are simple, inexpensive parts we carry on the truck.
A toilet that rocks is not just loose, it can break the seal underneath and leak onto the floor or subfloor. We reset it, replace the wax ring, and secure it so it sits solid.
A toilet that refills by itself every so often has a slow leak past the flapper. We replace the flapper and seat so the tank holds and the toilet stops cycling.
Toilet running or won't flush right? Call (717) 500-8923.
A single clog usually clears with a good flange plunger, and that is worth trying first.
What you should not do is keep flushing a clogged bowl, which only risks an overflow, or pour chemical drain cleaner into it, which can damage older pipe and rarely clears the real blockage.
Call us when:
That last one means the problem is past the toilet, in the main line, not the bowl. We clear the clog and, if it keeps returning, camera the line to find why.
When a toilet cracks, runs up the water bill, or simply needs an upgrade, replacing it is straightforward and often pays for itself in water savings. We remove the old toilet, haul it away, install the new one on a fresh wax ring and solid flange, and confirm it seals and flushes cleanly before we leave. A standard replacement is usually done in an hour or two, with no mess and no old toilet left in your garage.
Water pooling around the bottom of a toilet usually points to a failed wax ring, the seal between the toilet and the drain flange in the floor. Once that seal goes, water escapes onto the floor with every flush, and left alone it can rot the subfloor beneath.
The fix is to pull the toilet, replace the wax ring and any worn bolts, and reset it on a clean flange. In older Harrisburg homes we sometimes find a corroded or broken flange under the toilet, common with old cast iron, and we repair that too so the new seal holds.
If you see water at the base, stop using that toilet and call us before the floor takes damage.
Water at the base of the toilet? Call (717) 500-8923.
Repair handles most issues, but replacement is the better call when you see these.
Whether it is a quick repair or a full replacement, you get one local plumber and one flat price.
We confirm a same day window and ask what the toilet is doing, running, leaking, clogging, or due for replacement.
We find the real cause, a worn part, a failed seal, a flange issue, or a fixture past its life.
In writing, plus an honest read on whether a repair or a new toilet is the better spend.
Replace the part or install the new toilet on a fresh seal and solid flange.
Confirm it flushes and seals with no leaks, and haul away the old toilet on a replacement.
Cost depends on the work, a worn part is a small repair, while a full replacement or a flange repair runs more. We give a flat price in writing before we start, and an honest answer on whether a repair or a new toilet is the better value. The table below shows typical ranges so you know what to expect.
| Service | Typical cost in the Harrisburg area |
|---|---|
| Toilet repair (fill valve, flapper, flush parts) | $100 to $300 |
| Toilet unclogging | $60 to $240 |
| Wax ring or toilet reseal | $150 to $350 |
| Toilet installation or replacement | $300 to $800 |
| Bathroom fixture repair or install | $150 to $600 |
These are typical ranges, not quotes. Your final price depends on the toilet and the work it needs, and we put it in writing before any work starts. If a repair will serve you better than a replacement, or the reverse, we tell you straight.
We repair and install toilets across Harrisburg and the towns around it, the same day in most cases.
We cover Dauphin County ZIP codes from 17101 through 17113 and more. Not sure if we reach you? Just call and ask.
Most toilet repairs run about 100 to 300 dollars for worn flush parts, and unclogging runs about 60 to 240 dollars. A full toilet installation is about 300 to 800 dollars. We give a flat price in writing before we start.
A constantly running toilet is almost always a worn flapper or a faulty fill valve letting water slip from the tank into the bowl. It is a quick, inexpensive repair, and worth doing fast since a running toilet wastes a lot of water.
Usually a failed wax ring, the seal between the toilet and the floor drain. We pull the toilet, replace the wax ring and bolts, and reset it. In older homes we sometimes find a corroded flange underneath, which we repair too. Stop using that toilet until it is fixed.
Repair worn parts on a sound toilet. Replace if the tank or bowl is cracked, the toilet clogs constantly, or an old high-water unit is driving up your bill. We give you the honest math either way.
A standard replacement is usually an hour or two, including removing and hauling away the old toilet and setting the new one on a fresh seal. A flange repair or floor issue can add time.
Yes. We install whatever model you choose, whether you supply it or have us provide one. We help you match it to your bathroom's rough-in either way.
A comfort-height toilet has a taller bowl, closer to chair height, which is easier to sit down on and stand up from. It is a popular choice for older adults and for accessibility.
A flange plunger clears most single clogs. Do not keep flushing a clogged bowl or pour chemical cleaner in. If a plunger will not clear it, or other drains gurgle at the same time, call us, that can mean the clog is in the main line, not the toilet.
It can. Newer water-saving and dual-flush toilets use far less water per flush than older models, so replacing an old high-use toilet often pays for itself over time, especially if it was also running.
In most cases, yes. We carry common flush parts and wax rings on the truck, and we can usually handle a replacement in the same visit, even on weekends and holidays.
Have a different question? See all our plumbing FAQs.